ON-BOARD WEIGHING AND AXLE LOAD CONTROL SYSTEM FOR GARBAGE TRUCKS

On-board weighing system for garbage trucks

Rear-Loading Garbage Trucks Scales based on Pressure Sensors

Scales for Rear-Loading Garbage Trucks
The weight of the container is measured by the pressure in the hydraulic circuit of the tilting mechanism. The basic equipment of onboard scales includes:

1. Weighing controller — the central part of the system that converts signals from sensors into weight readings and then transmits information to the monitoring system.
2. Pressure sensors — high-precision original sensors that are installed in the tilting hydraulic system.
3. Position sensors — determine the weighing point.
4. GPS/GLONASS monitoring terminal.
5. Installation kit — consists of a sealed box, harnesses, fittings, a fuse with a terminal block, power and digital interface wires, and an automotive corrugated tube.

The feature of this system is the need for weighing only in a static mode with a stoppage of lifting and lowering for 2-3 seconds. At the same time, the system immediately weighs the weight of the full and empty container, allowing for automatic measurement of the weight of the garbage.

Weighing system with strain gauges for rear-loading garbage trucks

Garbage truck weighing system with strain gauges. The container weight is measured using strain gauges installed in the tilting pipe. The basic equipment of the onboard scales includes:

1. Weighing controller — the central part of the system that converts signals from sensors into weight readings and transmits information to the monitoring system.
2. High-precision weight strain gauges.
3. Position sensors — determine the weighing point.
4. GPS/Glonass monitoring terminal.
5. Installation kit — consists of a sealed box, harnesses, fuses with terminals, power supply and digital interfaces cables, and an automotive corrugated tube.

The feature of this system is the ability to weigh only in dynamic mode without stopping. At the same time, the system immediately weighs the weight of the full and empty container, allowing for automatic waste weighing.

The cost of onboard weighing systems starts from $3900 +VAT.

Onboard Weighing and Axle Load Monitoring System for Vehicles with Leaf Spring Suspension

Garbage Truck Scales with Leaf Springs. Measurement of axle loads and total vehicle weight is carried out by deformation sensors installed on the vehicle’s axles. The basic equipment of onboard scales includes:

1. A weighing controller — the central part of the system that converts signals from the sensors into weight readings and transmits information to the monitoring system.
2. High-precision weight strain gauges.
3. GPS/Glonass tracking terminal.
4. Installation kit — consists of a fuse with a socket, power and digital interface cables, and an automotive corrugated tube.

Optionally, a wireless or wired touch screen display or indicator can be supplied.

This equipment is not intended for measuring the weight of garbage in the container

The cost of onboard weighing systems starts from $1800 +VAT

Weighing system with load cells for side-loading garbage trucks

Scales for side-loading garbage trucks. Measurement of the weight of the garbage truck body is performed using load cells installed under the body. The basic equipment of the on-board scales includes:

1. Weighing controller — the central part of the system that converts signals from sensors into weight indicators and then transmits information to the monitoring system.
2. High-precision original weight load cells.
3. GPS/Glonass monitoring terminal.
4. Installation kit — consists of a sealed box, wiring harnesses, fuses with sockets, wiring for power connection and digital interfaces, and an automotive corrugated tube.

Optionally, a wireless or wired sensor display or indicator can be supplied.

Measurement of the weight of the garbage is only possible by changes in weight in the body.

The cost of onboard weighing systems starts from $4900 +VAT

VESA SYSTEM solutions

VESA SYSTEM

About us